Skyartec WASP 100 Setting Before Flight

Posted on 09 May 2012 by RC-Fever.com  

 

Some of you may find difficult to set the Skyartec WASP 100, here are the procedures of setting it.

Notes that before flight, you need to do some setting for the helicopter.

  1. Take out the Canopy.
  2. Turn the throttle to it's lowest position, then switch on the transmitter.
  3. Connect the battery to the helicopter and don't move it.
  4. You can see the red light on the receiver stop flashing, then you can disconnect the battery.

  5. Turn the throttle to it's highest position, then switch on the transmitter.

  6. Connect the battery to the helicopter and don't move it.

  7. You can see the red light on the receiver keep flashing.

  8. Turn the throttle to it's lowest position

  9. The red light on the receiver stop flashing indicate that the setting is finished. Enjoy it!!!